EEW 6.0 Motor

Description

This is a replacement motor for the EEW 6.0.  It is also the motor used in the EEW Cone Winder.

This motor will not fit the some EEW 6.1 since the pulley is different on that version.  If your pulley hole on the EEW 6.1 has a flat portion on center hole then this won’t fit unless you modify it.

This motor is about 10-20% slower than other brushelss motor listed on our site.  Other than the motor shaft not having a flat spot and it being slightly slower this motor is the same as the other brushless motor on our site.

To replace this you can use the included wrench to loosen the motor pulley.   After taking off the motor pulley use a Philips screwdriver to remove the two screws holding the motor in place.  Then unplug the motor and install your new motor.

Here is a video that shows how to install the EEW 6.0 motor.